can't get my low cut to fully low cut

[Zidia]

I'm using Fab Filter Pro Q to try and low cut, but i can't get it to fully work
These are my settings
I have the bottom fully cut off, but there is still noise there? What am i doing wrong here?

[Cardioid]

Take another fab filter under the original in the chain, and check how much db your lows have been dropped, should work well. And put that other one on Pre-EQ instead of post..

[Jay]

You can also apply 2 lowcuts in one instance of Fabfilter.

[Malgranda]

Or you could use the Bandpass from Melda Productions, also gives you a possibility to add and adjust a slope so you don't get those straight cuts other Bandpass plug-ins give you.

EDIT: If you decide to use it you obviously have one mixer slot less to use but yeah, it should at least solve your problem.

[Zidia]

Or you could use the Bandpass from Melda Productions, also gives you a possibility to add and adjust a slope so you don't get those straight cuts other Bandpass plug-ins give you.

EDIT: If you decide to use it you obviously have one mixer slot less to use but yeah, it should at least solve your problem.

I got the MFreeEffects bundle, the bandpass filter is exactly what i was looking for!
Thanks

[TheRavestyler]

Low and High Cut with Fabfilter Pro-Q works perfect enough said.